| 1 |
GNS3 Setup |
Install and configure GNS3 on your computer and setup your first network topology |
August 31, 2020 |
| 2 |
Intro to Router OS |
Use RouterOS to route between two subnets |
September 14, 2020 |
| 3 |
Static Routing |
Create static routes to inform the router about the location of subnets that are not directly attached |
September 21, 2020 |
| 4 |
Dynamic Routing |
Use dynamic routing protocols to allow the router to automatically learn the location of distant subnets |
September 28, 2020 |
| 5 |
Custom Subnets |
Create your own network subnets given some design constraints |
October 5, 2020 |
| 6 |
DHCP |
Enable Dynamic Host Configuration Protocol (DHCP) on subnets to simplify client network configuration |
October 12, 2020 |
| 7 |
VLANs |
Configure VLANs on the switches and router to provide for network isolation between sets of hosts on the same physical network |
October 19, 2020 |
| 8 |
Firewalls |
Configure a Firewall to restrict network access according to administrative requirements. |
October 26, 2020 |
| 9 |
Network Address Translation |
Connect your virtual GNS3 topology to the Internet and configure Network Address Translation (NAT) on a router |
November 2, 2020 |
| 10 |
GRE and OSPF |
Use a GRE tunnel and OSPF routing to connect a "remote" business office to a "headquarters" business network |
November 9, 2020 |
| 11 |
IPv6 |
Configure a dual-stack network to support both IPv4 and IPv6 |
November 16, 2020 |
| 12 |
OpenFlow |
Configure a routed network that uses Software-Defined Networking (SDN) over OpenFlow Layer 3 switches |
November 30, 2020 |